The importance of the technical operation of the ball mill

A few days ago , a company Xiuying District Haikou accident occurred . A worker in charge of operations at the mill hopper dredge , accidentally fell into the funnel was buried sand . More than an hour later, the workers were rescued , but had died of suffocation . Faced with this tragedy, we are saddened addition , there are more worthy people to pay attention to things that technical problems operating the mill , if he knows how to operate the mill , and perhaps would not have such a thing happen , so the following About mill operating techniques please be sure to pay attention .

      1, the ball must be closely gear dust cover to prevent dust and sand intrusion.

      2, the same workshop equipped with several sets of ball , not simultaneously start two synchronous machine .

      3 , the gap between the liner is to replace the 10-20mm ( when available oxygen welding cutting too tight ) .

      4 , must be strictly enforced to the mining , water supply , adding provisions ball prohibit overload, pay attention to prevent the occurrence of " belly up " phenomenon , but not too small for the amount of ore . But does not allow empty load operation , so bash liner.

      5 , as found when the large gear and main bearing sediment may have invaded or stop treatment immediately clear , and definitely not delay .

      6 , large tile mill fever, when the accident occurred at or near Burnt Burnt , forced cooling measures should be taken immediately not stop immediately, to avoid causing " axle " vicious accident.

      7, the ball no more than two consecutive start , the first and second time interval of 5 minutes or more. The third starter after starter must be electricians, fitters with the inspection .

      8 , fixing screws should be added hemp lining milling ring seal to prevent leakage , leakage of plasma .

Familiar words Death is final , since it happened , we can not restore what they can do to keep in mind that after the mill operating procedures to avoid similar incidents from happening again. The accident must be caused by various manufacturers and mill operator's attention.

http://www.vipeakballmill.com/ball.asp