Tips to extend the life of the grinder mill

Lack of attention during routine operation will reduce the mill 's life, the daily paper describes the process of using the mill 's need for attention , to ensure stable operation of the machine, to avoid losses to the enterprise .

      1 , the main transmission section mill with rolling bearing , and therefore must be run under good lubrication conditions , otherwise it will damage the bearings and shorten life. Spindle refueling time once per shift , it must be noted , found oil in the oil cup is no loss or loss is too slow , they should immediately wash the oil channel , plus 50 # machine oil, spindle oil cup in the upper position , the spindle base bearings , grinding roller bearings with grease gun filling each class 3 # lithium grease once every six months apart analyzer bearings cleaned once , add a little 3 # lithium grease , fan bearings plus lithium grease chamber

      2 , non- metal block into the machine , otherwise it will damage the grinding roller and grinding ring , or even the center hanger .

      3 , feeding should be uniform, not erratic . Excessive feeding duct will be blocked , reducing yields, easy to burn out the motor , charging too little will feed production. Feed size : hard materials in the appropriate diameter less than 15 mm , soft material for 20 mm diameter , non- bulk materials added to the machine .

      4 , the air volume control , located in the trachea into the wind turbine control valve , generally open to the maximum position , according to the fineness, production

      5 , the fine adjustment according to the size of the material , hardness, moisture content , the proportion of different processing of different thickness can be adjusted at the top of the analyzer , high speed , high fineness , low -speed, low fineness. Improve fineness, production will be reduced accordingly, if it is below standard debugging fan speed , users can be flexible .

      6 , ring roller mill scrap the limit, the remaining minimum wall thickness shall not be less than 10mm.

      7, parking , stop feeding, the host continues盍, the residual abrasive continue milling about a minute later, turn off the motor and the motor analyzer mainframe , stop grinding work , which then stops the fan motor , in order to purge the residual powder.

      The above points are prolonged VIPEAK Machinery Co., Ltd. to provide you with the use of mill life tips . As will appear in the actual production process of different problems, you can phone us, we have professional and technical personnel for you explain !

http://www.vipeakmill.com/